Hello,

I'm attempting to setup RP4VM to test the product.  I have installed the splitter on two hosts in two separate data centers, and installed 2 small vRPA's in each data center as well.  I've done the following steps:

• Confirmed that IP’s are correct on the WAN and LAN interfaces
• Added a route for the WAN interfaces so they can communicate with eachother
• Used the ping –I eth0 command on all 4 of the RPA’s and pinged all of the WAN interaces, and gateways with successful responses.
• From the GUI I attempted to connect the clusters, I keep getting ”Internal Error, please contact Customer Support”
• So I attempted from the CLI, I got to the point where I could accept the certificate, but then I get the following error: “Internal error. Error: An error occurred in communication to the new cluster. If cluster connectivity is over IP, check the IP connectivity over WAN. If cluster connectivity is over Fibre Channel, check the zoning. If the problem still persists, contact EMC Customer Support for assistance.”
• I rebooted all 4 of the RPA’s, and attempted to join the clusters again.  I couldn’t add the DC2 cluster to the DC1 cluster, but it allowed me to start the process from DC2 and add DC1, but I got the following error “Internal error. Remote cluster did not provide a certificate”

Does anyone have any suggestions of what to try next?

Thanks,

Aaron