Unsolved
This post is more than 5 years old
6 Posts
0
397
August 31st, 2008 08:00
DNS Timeout issue in failover
Hi All,
we are facing a unusual situation when doing a exchange 2k3 failover on the DR Site.
DOMAIN SERVER - INDIA
Primary Server - INDIA.
DR SERVER - MEXICO.
we have configured everything on the DR site by /disaster recovery switch, everything working fine on DR site. when we load the exchange module on the primary site it gives an error cant access remote registry . so we installed it on dr site and did a failover with specs disabled. but when we try to failback on the DR site . The Exchange system Attendent and Information Store services fails to start giving dependency error . when we check the ports by using netstat command. we found that the DNS service port takes much time establish connection. can anyone tell me how to increase its timeout value in replistor.
Thanks,
Pritam
we are facing a unusual situation when doing a exchange 2k3 failover on the DR Site.
DOMAIN SERVER - INDIA
Primary Server - INDIA.
DR SERVER - MEXICO.
we have configured everything on the DR site by /disaster recovery switch, everything working fine on DR site. when we load the exchange module on the primary site it gives an error cant access remote registry . so we installed it on dr site and did a failover with specs disabled. but when we try to failback on the DR site . The Exchange system Attendent and Information Store services fails to start giving dependency error . when we check the ports by using netstat command. we found that the DNS service port takes much time establish connection. can anyone tell me how to increase its timeout value in replistor.
Thanks,
Pritam
No Events found!
jschrade1
2 Intern
•
106 Posts
0
September 2nd, 2008 11:00
However, from your question, I don't think that is what is causing Exchange to fail on the Target site. It would probably be a good idea to contact EMC Support for further diagnosis.
JS