Unsolved
This post is more than 5 years old
79 Posts
0
1254
December 5th, 2010 22:00
heartbeat checker/sender time warp problem
Hi,
My AutoStart 5.3 SP4 with hotfix got the following messages during running,
Warning FT By: ftProcMon on Node: cn-vwm-561
Node cn-vwm-561 heartbeat sender time warp of 903 seconds
Warning FT By: ftProcMon on Node: cn-vwm-561
Node cn-vwm-561 heartbeat checker time warp of 903 seconds
Any negative effect?
No Events found!
yito1
262 Posts
1
December 5th, 2010 22:00
Hi,
When system clock is corrected, this event is displayed.
There will not be problem.
ecervant
63 Posts
0
December 6th, 2010 09:00
The message usually indicates that the heartbeat message was delayed as the ftProcMon process expects to receive consistent heartbeat messages to know the AutoStart nodes are still running. In your example, it indicates that the heartbeat message was delayed by 903 seconds. AutoStart should be able to resume heartbeat communication during an occasional network spike (delay) and it should not affect AutoStart functionality.
If the messages occur at a consistent time, it could indicate some maintenance on the network that is affecting network communication. In this instance, it would be a good idea to investigate the maintenance to see if it can be fine tuned to not affect AutoStart and other communication.
If you consistency see these messages in the AutoStart Domain log, then it could indicate that there may be trouble with communication over the network.