Unsolved
This post is more than 5 years old
11 Posts
0
360
December 21st, 2009 15:00
Device mapping and masking for windows cluster
Hi All,
Could you please explain the process/ share the document which has instructions on mapping and masking device for windows cluster.
Regards,
Kalyan Guturi.
0 events found
No Events found!
AranH1
2.2K Posts
0
December 21st, 2009 15:00
It really isn't any different than mapping and masking a device for a stand alone host. Just map the device to the desired FA ports, zone all nodes of the cluster to those FA ports on your switch, and then mask all the devices to all cluster nodes. Apart from that just follow the Microsoft documentation for configuring the devices in the cluster.
If your windows clusters is running Windows 2008 there are specific bits to enable on the FAs. This is covered in the ESM.