Unsolved
This post is more than 5 years old
22 Posts
0
435
November 12th, 2009 01:00
DMX 4 - Managing using SMC & ECC v6
We have DMX 4, and we used to manage it using SMC, right now i have some issue in SMC hence I am planning to use ECC to expand one of the meta lun.
The meta lun was created using SMC and now i am planning to expland it using ECC, will it create any issue in performance..
Note : no data on the meta.
Request someone to respond immediately.
The meta lun was created using SMC and now i am planning to expland it using ECC, will it create any issue in performance..
Note : no data on the meta.
Request someone to respond immediately.
No Events found!
Arifrahman
5 Posts
1
November 12th, 2009 02:00
I think its all the same symcli commands whether u r using SMC or ECC.In ECC u can easily do the task by just right click on the specific Lun where u will get the "Meta Lun Configuration" and from that menu you can expand the Lun as your wish.But i think it will allow u only the concat volume not the stripe.
///Arif