since you are talking about just one device (out of multiple) on the same target, I would find it very unlikely that the HBA is defective. If that were the case, you would be seeing all paths to/from that HBA showing up with an error message. To check more precisely you could perform a:
powermt display dev=all
to see if it's just for that one device.
Have you by any chance checked to see if any changes were made in the mapping/masking/zoning? Also, you could try to check if anything changed in your sd.conf that might have caused this.
Raayman
47 Posts
0
March 1st, 2010 03:00
Hi,
since you are talking about just one device (out of multiple) on the same target, I would find it very unlikely that the HBA is defective. If that were the case, you would be seeing all paths to/from that HBA showing up with an error message. To check more precisely you could perform a:
powermt display dev=all
to see if it's just for that one device.
Have you by any chance checked to see if any changes were made in the mapping/masking/zoning? Also, you could try to check if anything changed in your sd.conf that might have caused this.