Unsolved
This post is more than 5 years old
3 Posts
0
917
SRDF config question
Hi
I have 2 x 2 VMAX 40k in 2 locations (50 miles distance).
SRDF is configured between A -> B , C -> D (all VMAXs are in pairs)
SRDF doesn't have separate fabrics.
Now I was asked to setup additionally srdf between arrays A - > D
On array A i have 4 directors RF and one RDF group.
Is it all good if from 1 source array I have srdf zoned to 2 destination arrays ? I'ts not concurrent srdf. I's just 1 to many relation for different RDF groups.
Is that topology supported ? Are there any problems I could expect ? What are the steps to properly configure that.
Rgds
Slaw
dynamox
1 Rookie
1 Rookie
•
20.4K Posts
0
January 20th, 2016 18:00
sure, you can have one to many configuration. Zone RDF ports between arrays and create RDFG.
bboguslaw
3 Posts
0
January 21st, 2016 14:00
Thank you for confirmation.