Unsolved
This post is more than 5 years old
22 Posts
0
542
August 3rd, 2010 10:00
Verifying enabled bit flags from Solutions Enabler
After enabling the SPC2/OS2007 bit flags on an HBA, what command do you run to verify that the flags actually enabled on the WWPN/HBA?
symmask -sid XXXX set hba_flags on spc2,OS2007 -enable -wwn XXXXXXXXXXXXXXXX -dir 10A -p 1
Thanks
0 events found
No Events found!
KeystoneCruiser
22 Posts
0
August 3rd, 2010 10:00
Thanks that was fast and it worked great.
dynamox
9 Legend
•
20.4K Posts
0
August 3rd, 2010 10:00
symmaskdb -sid 123 list db -wwn 50014380011d10a4 -v
Jurjen_Oskam
56 Posts
0
August 9th, 2010 02:00
Beware that the symmaskdb command only shows the overrides, and that (some of) the flags set on the FA port could still be visible to the host. So, if you want to know which flags are in effect for a host, you need to look at the flags on the FA port and then add or subtract any overrides.