PE2650 BSOD'ing when installing Adaptec 39160 SCSI controller card

I am futilely trying to install an Adaptec 39160 into a PE2650. I am running Array Manager Ver. 3.5.

After some research I found "IMPORTANT NOTE: If you are running Open Manage Array Manager v3.2 or higher under Windows 2000, to avoid a potential Blue Screen, prior to updating the driver you will need to:
1. Disable the SCSI subsystem provider in the Array Manager Utilities before upgrading the driver. Please refer to the Array Manager documentation for details on how to do this.
2. Once the SCSI provider is disabled, you should then navigate to the \WINNT\SYSTEM32\DRIVERS folder and temporarily rename ASPI32.SYS to ASPI32.XXX, then reboot the system before proceeding with the upgrade.
3. Following the upgrade, you will need to reboot again before re-naming ASPI32.SYS back to its' original name, then finally re-enabling the SCSI provider."

I have scoured the documentation and have not been able to pin-point how to " 1. Disable the SCSI subsystem provider in the Array Manager Utilities before upgrading the driver. Please refer to the Array Manager documentation for details on how to do this."

So, how do I disable the SCSI subsystem in the Array Manager Utilities? Or, where can I read up on how to do this?

Any help would be greatly appreciated.