Unity 300 Health Check Failed

Question

Hello all, I have a Unity 300 on firmware 5.1.1.0.5.005, I'd like to update the firmware but am unable to pass the health check.  The support article tells me to check the hosts page and make sure there is redundancy, our hosts page used to have 2 hosts but they have been deleted, any idea's how to get past this with no hosts? Error link goes here: Dell EMC Unity: Error Code 'flr::check_server_connectivity_2' during Pre-Upgrade Health Checks (User Correctable) | Dell US

DELL-Sam L · Answer

Hello Unknown_Name_Here, A host must be connected to the correct ports on both SPs because each SP will be rebooted during the upgrade.

Unknown_Name_Here · Answer

Thanks for the Reply DELL-Sam L.  I understand that from the support article, but we have no hosts configured.

Unknown_Name_Here · Answer

They have been removed from use, I think I just found the issue under Access then Initiators though, I'll follow up next week if that is it.  Thanks

DELL-Josh Cr · Answer

Is there a reason why the hosts were deleted? Can you re-add them and do the upgrade? There is not an easy way to bypass the check.

Unity

Was this post helpful?