Unity

Question

Hi,I have a bunch of LUNs within a Consistency Group that have trespassed/owner changed to the other SP and I would like to reset all of those LUNs back to the default owner. Is there a command that I can run to do this?Also, is there a better way to only list those LUNs that are trespassed? I used the following command, but it lists all of the LUNs:uemcli /stor/prov/luns/lun show -filter 'Name, Trespassed'Thanks,

macyero · Answer

I also used the following command to put into a table:uemcli /stor/prov/luns/lun show -filter 'Name, SP owner, Health state, Trespassed' -output table

macyero · Answer

Array is on old code. 4.4.x

DELL-Sam L · Answer

Hello macyero, Which Unity system and what is your current OE version?

DELL-Sam L · Answer

Hello macyero, Have you tried to run the following command to see if the luns return back to their owner SP? uemcli -h trespass mine OR uemcli -h trespass mine

macyero · Answer

I don't see trespass available for uemcli on the Unity 4.4.x. Any way to run uemcli to go back to its owner?

DELL-Sam L · Answer

Hello macyero, You are going to have to use the gui to trespass the luns back to their owner.  Here is a link that shows the steps. https://dell.to/3rHBEl0

macyero · Answer

trespass isn't an option in Unisphere or from the uemcli. I don't see it listed in the customizing the columns. The only way to change this is editing each LUN and changing the owner. There must be a way to do this on a bunch of LUNs? What if there were Consistency Groups and each consistency group had 50 LUNs? I would have to go into each Consistency Group and try to find the LUN to modify the owner. There must be a way to do this from the CLI

DELL-Sam L · Answer

Hello macyero, I have not found any other way of doing it via cli.

Unity - Trespass, CLI to set back to default owner

Was this post helpful?