UNSOLVED
SRM 3.6
Hi,
We upgraded to 3.6.1 last week and I've to say I'm quite impressed with the whole experience. The thing that I'm most psyched about is that a lot of our feedback, from EMC World, is incorporated in there. In the four years that I've been to EMC World, this is a first! Here is shout out to Gaytri and Florian whom I spoke to at length.
Now a couple of questions -
1. I see two folders for pretty much all the platforms in the Alerting module. Is this a known issue?
2. Are we supporting HP arrays behind VPLEX yet?
Thanks!
989
0
Posted January 27th, 2015 06:00
#1 - There is no way to delete the entire folder? Is the expectation that we delete an alert at a time!? That's not good at all...
#2 - When is support for P9000 behind VPLEX coming?
989
0
Posted January 27th, 2015 07:00
Hi,
In reference to the P9000, this is a public community, so unfortunately we cannot provide information about future releases here. Please contact your EMC account team, who can forward the question to us.
989
0
Posted January 27th, 2015 07:00
Hi again,
Unfortunately there is no way to delete the entire top level folder. However, you could go to the subfolders, select all and delete. So it's not a one click operation but is not as bad as you would think.
I hope this helps...
Thanks,
-Gayatri
989
0
Posted January 28th, 2015 11:00
Will do.
989
0
Posted January 28th, 2015 11:00
Ok, I guess it's better than having to delete them one at a time. Thanks.
989
0
Posted February 13th, 2015 00:00
Hi Michael,
SRM 3.6.1 is GA since January 16, 2015.
Release notes etc... available from https://support.emc.com/products/34247_ViPR-SRM and https://community.emc.com/docs/DOC-40525
Regards
Conor
989
0
Posted February 13th, 2015 00:00
Is ViPR SRM 3.6 GA yet?
We are having a nightmare with 3.5 and EMC's recommendation is to do a fresh install with 3.6. However, I am not in favour of doing that if it is not GA.
Any official word?
Regards
Michael
989
0
Posted February 13th, 2015 01:00
Great, thanks Conor.
garyan
42 Posts
989
1
Posted January 26th, 2015 14:00
Glad to know that your feedback made it in, Mr. Smith.
Yes, #1 is a known issue. You would need to manually delete the "older" definitions. Note that the latest 3.6 versions of alert definitions are found in the folders ending with the term 'definitions'. I believe this is documented in the upgrade doc.
For #2, what specific HP model do you have in your environment? We added support for HP 3PAR behind VPLEX with 3.6. However, HP P9000's are not supported yet.
HTH.
-Gayatri