I was eventually able to get the C90LE7 WES7 communicating and registered to the WDM server. I had to uninstall and reinstall the Wyse Device Agent (12.0.0.113).
Still cannot issue any real-time commands to any of the terminals. I am currently looking into the scope configurations. According to the guide there are quite a few ports that will need to be opened.
Interestingly enough, commands take precedence after the Wyse terminal has been manually rebooted on the client side. I was able to push out a package successfully to the C90LE7 after I rebooted the terminal.
Doesn't quite work the way I would have liked it, but at least it's something for now. Will continue to investigate why real-time commands are not working. Keep posted...
I actually have the same sort of issue, 5020's that I have won't seem to take commands until after manual reboot. Typically it happens that I push, then reboot, then it starts to run the package.
I had a similar issue when on Firmware version 8.0_x on our Wyse. Once I upgraded to 8.1 and above, the issue seemed to clear up. This was on C10LE and D10Ds.
DFixer
3 Posts
0
December 8th, 2016 10:00
Update:
I was eventually able to get the C90LE7 WES7 communicating and registered to the WDM server. I had to uninstall and reinstall the Wyse Device Agent (12.0.0.113).
Still cannot issue any real-time commands to any of the terminals. I am currently looking into the scope configurations. According to the guide there are quite a few ports that will need to be opened.
I will keep everyone posted.
DFixer
3 Posts
0
December 8th, 2016 11:00
Interestingly enough, commands take precedence after the Wyse terminal has been manually rebooted on the client side. I was able to push out a package successfully to the C90LE7 after I rebooted the terminal.
Doesn't quite work the way I would have liked it, but at least it's something for now. Will continue to investigate why real-time commands are not working. Keep posted...
jason.clemons
2 Posts
0
December 8th, 2016 12:00
I actually have the same sort of issue, 5020's that I have won't seem to take commands until after manual reboot. Typically it happens that I push, then reboot, then it starts to run the package.
dcook1300
5 Posts
0
April 3rd, 2017 08:00
I had a similar issue when on Firmware version 8.0_x on our Wyse. Once I upgraded to 8.1 and above, the issue seemed to clear up. This was on C10LE and D10Ds.