Unsolved
This post is more than 5 years old
2 Posts
0
12094
July 6th, 2015 01:00
Trouble connecting using RDP
Trouble connecting using RDP
I'm just getting my feet wet with WYSE WT1125SE. I am using Windows 7 Professional on my PC and want to RDP to it using my WYSE terminal. I have my WYSE and my PC connected to a switch. I am not on a domain.
When I boot up my WYSE and double click RDP, I enter the IP address of my PC, the log on window comes on and off very quickly. It is as if I am connected but cannot see the PC screen. I can only see with WYSE screen, green with the ICA and RDP icons.
I can RDP to my PC from my laptop without any problem. I can also see the PC and VM workstations running on the PC in my network connections in Windows 7 but cannot see the WYSE.
Any ideas?
gerardaroy
2 Posts
0
July 6th, 2015 01:00
I can also ping my PC and vm workstations running on the PC from the WYSE ping test.
Rmontalvo1
623 Posts
0
July 6th, 2015 01:00
You may want to check the "Remote" settings on your Windows 7 PC and verify that you are not using "Network Level Authentication" to connect. The 1125SE is too old and does not support this feature.