Unsolved
This post is more than 5 years old
1 Message
0
66369
May 8th, 2015 10:00
Xenith tx0 Trap: Data abort
Xenith tx0 Trap: Data abort
Hello, I am having this issue with a particular user.
I got this error messages when the user leave the computer idle for a few minutes.
Trap: data abort, EIP 0xc0146f00, CR2 0xa5a
T00_xen 2.0_105: [ip address] (hub daemon:11)
Trap: data abort, EIP 0xc01a8b90, CR2 0x302046f
T00_xen 2.0_105: [ip address] (screen saver:7)
this two messages prompt me to reboot the terminal but I would like to find a better solution than power cycle.
Rmontalvo1
623 Posts
0
May 8th, 2015 10:00
Israel,
Trap errors are normally an indication of a problem on the firmware. I would go ahead and get the latest firmware (HF 2.0_214) installed on the device to see if it takes care of the problem.
Roger Montalvo
Visit our Dell Wyse Thin Client Knowledge Base and Manuals web site at www.wyse.com/KB
Visit our Dell Wyse PocketCloud Knowledge Base and Manuals web site at http://pocketcloudsupport.wyse.com/forums
[SIGPIC][/SIGPIC]