UNSOLVED
Monitor mode ipw3945 (Inspiron 9400)
I can't set monitor mode with iwconfig ...
# iwconfig eth0 mode Monitor
Error for wireless request "Set Mode" (8B06) :
SET failed on device eth0 ; Invalid argument.
How can I do it ?
here http://ipw3945.sourceforge.net/README.ipw3945 i red this : NOTE:Monitor is only available if CONFIG_IPW3945_MONITOR is enabled. >> Where must I enable this option ?
thanks, bye!
# iwconfig eth0 mode Monitor
Error for wireless request "Set Mode" (8B06) :
SET failed on device eth0 ; Invalid argument.
How can I do it ?
here http://ipw3945.sourceforge.net/README.ipw3945 i red this : NOTE:Monitor is only available if CONFIG_IPW3945_MONITOR is enabled. >> Where must I enable this option ?
thanks, bye!
Message Edited by ale46 on 07-07-200605:02 PM
Message Edited by ale46 on 07-07-200605:02 PM
