Hi,

Did you add the VLANs to the ports?

On the 5548

interface tengigabitethernet1/0/1

switchport trunk allowed vlan 10, 200

Page 503 http://downloads.dell.com/Manuals/Common/PowerConnect5500_CLIRef_en-us.pdf

Even with this configuration, not worked!

Did you set the vlans on the force10 side as well?

http://downloads.dell.com/Manuals/all-products/esuprt_ser_stor_net/esuprt_networking/esuprt_net_fxd_prt_swtchs/force10-s4810_Owner%27s%20Manual8_en-us.pdf

Page 786

What does the command show?

show interfaces switchport

Is VLAN 1 a tagged or untagged vlan?

Name: TenGigabitEthernet 0/39

802.1QTagged: Hybrid

Vlan membership:

Q       Vlans

U       1

T       10, 200

If vlan 1 is untagged you should change the port mode on the powerconnect from trunk to general.

Not that I'm aware, but how can I see this?

Are you running the ping from the notebook or from one of the switches?

Josh, for testing purposes I did the following configuration. The goal here is to use the VLAN 200 (tagged and existent on S4810) on the Powerconnect:

The config on powerconnect:

!

interface tengigabitethernet 1/0/1

switchport mode general

switchport general allowed vlan add 240 tagged

!

interface gigabitethernet 1/0/37

switchport mode general

switchport general allowed vlan add 240 tagged

!

then I put my notebook on the gi 1/0/37 on powerconnect. I use Wireshark to capture traffic and see the traffic from vlan 240, but I cannot communicate whit this network. I'm only receiving data, but I cannot make a ping connectoin for example.

What I'm doing wrong?

Run the command on the 5524 ip routing.

from notebook