Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
Solved!
Go to SolutionAM
Abdurrahman Mem
1 Rookie
•
1 Message
0
422246
July 30th, 2010 04:00
System Services not available
Hi All
I've have a Dell PowerEdge R610 server that I've been setting up. During the setup process I enter the Unified Server Configurator and ran the Platform Update. Since then I have been unable to access the USC. From the main boot screen the following line is displayed "System Services update required" and in the BIOS Boot Manager "System Services not available". I need to know what to do to update the System Services.
Thanks
I would start by resetting the idrac to defaults. On bootup, hit Cntrl E and set the idrac to defaults. If this still doesnt work, power down the system, and pull power for one full minute. Then plugin power and let the system sit for 1 full minute before powering on. After you power on, you may system System Services not available for about 5-10 minutes. Any longer than that and try the info below
Page 51 http://support.dell.com/support/edocs/software/smusc/smusc/1_1/en/UG/pdf/USCUGMR.pdf
DELL-Erman O
Moderator
•
2984 Posts
•
14874 Points
12721
0
Posted December 8th, 2021 04:00
Hello,
Can you try the steps sanjivus suggested,
I am also adding the new repair version here Dell LifeCycle Controller v1.7.5 Repair Package https://dell.to/3lLa3tx
Installation instructions
1. Download the file (.usc) onto your storage media (USB key or hard drive).
2. Connect to iDRAC on your system using the iDRAC web interface. For more information on the iDRAC, see the iDRAC User's Guide.
3. From the iDRAC web interface, click "Remote Access".
4. Select the "Update" tab, and then browse to the image you downloaded in step 1.
5. Click "Next", and then click "OK" to confirm the upload. Allow the process to complete before you continue to step 6.
6. Reboot your system, and then press the key to enter the Unified Server Configurator interface.
7. Select "Launch Platform Update" to complete the installation of all recommended updates.
Let us know how it goes!
DELL-Erman O
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
sanjivus
1 Rookie
•
21 Posts
54592
3
Posted June 17th, 2016 15:00
If someone is still looking for this information, here is what I did to resolve this issue:
Download the Lifecycle Controller Repair Package from
www.dell.com/.../DriversDetails
http://www.dell.com/support/home/us/en/19/Drivers/DriversDetails?driverId=7Y5M4
Upload the this package using DRAC's firmware upload interface.
Reboot the server and predd F10 to goto the System Services.
Goto USC settings and configure the IP address information.
Goto platform update and select ftp as source.
keep ftp.dell.com as URL and click next .
Select the Lifecycle Controller for update in addition to whatever else you want to update.
Take a cup of coffee sit back and let the magic happen on its own.
Hope this helps.