Avamar 7.1 single node workflow - Switch config tab resolution

Hi all,

during a single node installation on v7.1 SP1 145, i encountered a strange behaviour.

Workflow in AVI installer displayed all normal tabs and a "Switch config" additional tab (as hardwaqre detected an utility node and storage nodes). This tab was marked with red exclamation symbol, so it was impossible to continue the installation.

Resolution :

Fill all the tabs with Save action on each filled tab.

In "Switch config" tab, blank all the fields and click save button.

Exit from Avamar installation manager.

re-sign on and activate support mode.

When installation package is displayed, click Install button.

Detection starts (a few minutes later, workflow displays tabs to fill).

At this point, "Switch config" tab may no longer be present.

Enjoy with single node installation process.

Andre

APX France