Hi,

Please check this thread,it gives you some information about replication:

https://community.emc.com/thread/178895

Thanks

Jyothi

No what I was looking...

My idea is to copy all the data from the celerra to the new VNX and then create a manual checkpoint and only do a refresh between the NX and the VNXe, to avoid full syncronization between the storages,  is this possible?

thank you

Maybe this will help to understand better:

I'm not familiar with the VNXe, but I believe the procedure you are referring to is called incremental attach. Replicate the NS42G to the VNX. Stop host access to the filesystems you are cutting over, create a fs_ckpt of the source file systems on the NX4 and VNXe, refresh replications on the source (NX4/VNXe) and refresh on the old target (NS42G), delete replications between NS42G and VNX and also between NX4/VNXe to NS42G, and then create replication on NX4/VNXe from the base checkpoint to the VNX. That's a high level overview of the incremental attach procedure.

Great that was what I was looking for, great, thank you Chris

Now I just need to verify the VNXe to be sure this could complete work.

I am not sure if you can use incremental attach with a VNXe

You would have to drive it from the VNX side

I would suggest to try with a small test fs

Hello All,

Can i get any documention to configure the replication between Celera to VNX.  I have configured the same however i need to submit the document to the customer ... I have downloaded one doc but it was content protected so cannot copy any data from that... If anyone have the document kindly inbox me at ragavs2908@outlook.com

Thanks in advance,

Ragav Sidhu