Solved!
Go to Solution- First check the status of the blade after installation. It should power up automatically:
switch# show module
Mod Ports Module-Type Model Status
--- ----- -------------------------------- ------------------ ------------
1 16 1/2 Gbps FC Module DS-X9016 ok
2 32 1/2 Gbps FC Module DS-X9032 ok
3 48 1/2/4 Gbps FC Module DS-X9148 ok
4 32 Storage Services Module DS-X9032-SSM ok
5 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 ha-standby
6 0 Supervisor/Fabric-1 DS-X9530-SF1-K9 active *
8 24 1/2/4 Gbps FC Module DS-X9124 ok
9 24 1/2/4 Gbps FC Module DS-X9124 ok
You should see something similar to the above with your line card listed and the status as 'ok'. If it is not powered up, go into 'conf t' and powerup the module:
switch# no poweroff module X (where x is the module number) ConnectrixHelpe
259 Posts
487
0
Posted October 28th, 2008 08:00
That's a pretty wide open question. It depends on the blade you're installing, the switch it is going into, the configuration of the switch, and the code on the switch. Can you provide more exact detail in regards to what blade, switch, etc.?
Thank you.
healyj
141 Posts
487
0
Posted November 28th, 2017 06:00
Hi there,
In our effort s to clean up the forum, we came across your question / statement.
If the question / statement is still valid, not expired and you need an update please reach out again and we try to get it answered.
As for now we set it to “answered.”
Regards,
Jim