
Solved!
Go to SolutionSSD disk upgrade - compatibility with Latitude E6420 - E6430
Hi team,
My question is the following :
Is it possible to upgrade Latitude E6420 - E6430 from a simple HDD to a SSD disk ?
Technically, I know that it's possible, but several technicians from Dell sub contractors are sure that there is a lot of issues with this upgrade.
Indeed, in my company, we did this upgrade on a E6430 yesterday for a beta client. This morning, this client called me to report that after laptop switching on, the screen shows " No bootable device found".
Are you aware about this kind of problems ?
Thanks,
Max
4 people also have this problem
Responses (24)
Solutions (0)
I have experienced the same issue. My SSD drive was not detected. I updated drivers and so on, without any effect.
By chance I figured out that it was a purely mechanical issue. The ssd drive is a little thinner than the usual hard drive so that it did not get into contact with the slot.
I resolved it by sticking some layers of tape on the tip of the ssd in order to make it apparently thicker.
See the photos.
This is caused by the initial hard drive being installed as ahci drive not raid or legacy. It doesn't clone well to ssd drives. There is two extra hidden particians in Windows 8 onwards to support ahci and as a result Samsung magician doesn't do the trick. I ended up restting bios to ahci andbooting from windows disk. There are ways around it but they are tedious. eg."
While in Windows 8, open msconfig.exe and go to the boot tab and check Safe Boot. Click Apply and OK, and allow restart.
Boot back into the Bios and change the controller to AHCI. Saving the change which will cause your system to reboot.
This time, let it continue the boot into Safe Mode. While there, Windows 8 will install the AHCI drivers. You can check the SATA controllers in Device Manger to make sure if you want. The drivers that were missing were now there in device manager.I didn't get any sort of pop up that the drivers were installed.
Open msconfig.exe again and uncheck the Safe Boot box on the Boot tab.
Reboot your system normally." quoted from another forum.
Why would it be an issue, you are swapping a 2.5" SATA HDD with a 2.5" SATA SSD. Just make sure properly clone the hard drive and re-format the entire HDD after you verify the SSD works okay. We have several people at work who replaced their E6420 with Samsung EVO 500GB SSD. They only rave about how fast their system is now and how they wished they had switched sooner.
Thanks but this response doesn't help me !
I just need to know if any SSD device is compatible with E6420 - E6430 Latitude serie and what is the best configuration in the BIOS.
In my case, I am swapping the HDD with a SSD and I do a full Windows reload. For the first upgrade, after 1 day, unable to start Windows, the SSD is not recognized in the BIOS anymore.
If you didn't change the configuration in the bios and no other hardware failed, your ssd died. Get it replaced and do the process again with a new reputable ssd. Fyi, dell sells configurations of e6430 with ssd pre-installed. There's no issue using ssd.
I upgraded me E6440 with a Samsung 850 PRO SSD 512GB. I took the standard 320GB out and swapped it with the SSD after I ran Samsung Magician. There was no BIOS change necessary. Whatever the defaults that come delivered with Dell will be fine to use with the HDD or SSD (when you clone the HDD to it).
Same problem with ssd disk on a E6420.
If I restart the machine, it would not find the disk, resart again and it starts normaly. Everytime.
If I shut down it starts normaly 9 out of 10 times, byt every restart is a problem.
The disk works fine in a lot of other machines.
I have tried 2 different ssd disks with same result.
My Latitude e6420 has a problem with SSD.
I tried several times with different BIOS settings and with several BIOS versions, including the latest version (A21).
It behave randomly. Most of the times it doesn't recognize the SSD at all.
Hopefully someone will find a solution for this.

cacoodle
1 Message
86854
1
Posted March 15th, 2015 22:00
I m having the exact same problem, having cloned my HDD to SSD and attempting to replace the unit in my Latitude 6420 -- following the swap, I keep getting this screen:
"No boot device found. Press any key to reboot the machine,"
following the preceding messages:
"PXE-E61: Media test failure, check cable,"
and
"PXE-M0F: Exiting Intel Boot Agent."
Max, did you ever find a way to resolve this issue? I would be grateful, as the replies below don't seem to address the problem I am facing.
Many thanks -- to anyone with feedback here!