Hello,

I have a Dell M6348 that we utilize to boot our blade OS's via iscsi.  We currently have two fiber connections to this switch in ports xg1 and xg2.  We would like to combine both of these connections into one, and assign that to all of the internal ports utilized by all of the blades.  Each fiber connection goes to a different switch on our network, so the hope is if we lose a main switch on our networking side, that we have some built in redundancy.

I beleive we need to setup a LAG to combine both of these ports.  We would then like to assign that LAG to use a specific Vlan.  Are their good documented procedures on how to go about doing this?  The M6348 manual leaves a lot to be desired on the best approach to take for a setup like this.

Thanks for any help.