UNSOLVED
SANCopy with Windows cluster
Hi,
I have transfered 500 GB of CLARiiON CX700 to CX-3 in Windows cluster environment by using SANCopy(full- after shutting down servers). data was sucessfully transfered on target array but target server are unable to read the data.
zonning, masking, mapping is correct. do u have any idea what else need to be done.
Thanks.
I have transfered 500 GB of CLARiiON CX700 to CX-3 in Windows cluster environment by using SANCopy(full- after shutting down servers). data was sucessfully transfered on target array but target server are unable to read the data.
zonning, masking, mapping is correct. do u have any idea what else need to be done.
Thanks.
427
0
Posted November 29th, 2007 00:00
Hi,
Thanks for the answer! Unfortunately Sync 2.0 also requires a drive letter
Message was edited by: Sorry for posting this in the wrong thread
ATmike427
0
Posted November 29th, 2007 04:00
Cluster services started up correctly ? Enabled your cluster resources, booted the nodes in the right order ?427
0
Posted November 29th, 2007 07:00
This looks so much like a MSCS (Microsoft Cluster Service) problem.... I know this doesn't help, but I've seen it too many times....427
0
Posted November 29th, 2007 07:00
Yes, OS can see the drives but can't recognize the file systems and data. disk looks healther to OS.427
1
Posted November 29th, 2007 11:00
amol,
RRR might be onto something here ....were cluster resources taken offline before the source system was shutdown ?
Even thought disk signature should not have changed, i have seen it where it does change ..take a look at this and rule this out:
http://support.microsoft.com/kb/280425427
0
Posted November 29th, 2007 13:00
Thanx for your help Dynamox.
Yes, cluster resources were shutdown during the migration.427
0
Posted November 29th, 2007 14:00
did you have any luck validating what signature dumpcfg see on the disk and what you have in the registry ?
dynamox
11 Legend
•
20419 Posts
•
87439 Points
427
0
Posted November 28th, 2007 19:00