Welcome to the Dell Community @Pond511 

Could you take a picture of the damage and post it.

The panel can be replaced but there could be more damage than just that.

https://www.parts-people.com/index.php?action=category&id=145&subid=741&refine=lcd+screen

Best regards,

U2

@U2CAMEB4ME This is the picture of the broken part, it isn't completely came off just have a big gap and when the screen fold and unfold it widen a bit.

Thanks a lot  

@U2CAMEB4ME 

@Pond511 

If it is not separating at the base and only the LCD lid.

Then you may only need to replace this.

https://www.ebay.com/sch/i.html?_from=R40&_nkw=0DC02Y&_sacat=0&_sop=15

Regards,

U2

@U2CAMEB4ME So what did you said is that if the base wasn't split then I only need to replace the back panel part, I will look further more to it

Thanks a lot. 

@Pond511 

Yes if the base has not begun to split then you may only need the lid.

This is what to look for.

This is not your model, just a representative.

If the base screws are all intact then the lid will just need to be replaced.

While your in there checking tighten down any screws that are loose.

https://www.dell.com/support/manuals/en-us/vostro-14-5480-laptop/vos14-5480om/working-on-your-computer?guid=guid-9ccd6d90-c1d1-427f-9e77-d4f83f3ad2b6&lang=en-us

Regards,

U2

Thanks for the advice and the instructions link, I will look for any loose screws and other damage as well. I'm a newbie at removing a PC so what did I have to remove to get access to that area? 

@Pond511 

Look in the manual for "Remove the Base Cover"

Removing the base cover should give you access to the Base Hinge Screws.

Check for any damage or loose screws.

Regards,

U2

@U2CAMEB4ME upon my removal I found only the hinge was broken, the other parts still intact and all the screw are tight. 

Is this it?

Is this what I have to look for?