Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
UNSOLVED
D2
DeaconZ28-2015
1 Rookie
•
252 Posts
0
518
July 31st, 2008 06:00
SP faulting
Hi, I'm posting this in a new thread because the one where I posted it in has had the original question answered.
I'm trying to attach a DAE2-ATA to a CX3-40f.
My CX has three buses already in use, and I would like to put this DAE2 on its own bus (BE 3) since its 2Gbps.
I have followed the procedure with NST, but everytime I plug the cable into the SP it faults. I don't even plug in the other end.
I'm wondering if its the cables, but I have tried two of them. I had to have them made by a third party cable vendor since the CX3 uses SFP on its end and the older DAE2's use HSSDC1 on the PRI port instead of HSSDC2.
If I plug in a SFP-HSSDC2 cable into the SP it is fine, but obviously that doesn't help me with the DAE2.
Please help. I need this ATA array to implement a backup to disk scheme.
I'm trying to attach a DAE2-ATA to a CX3-40f.
My CX has three buses already in use, and I would like to put this DAE2 on its own bus (BE 3) since its 2Gbps.
I have followed the procedure with NST, but everytime I plug the cable into the SP it faults. I don't even plug in the other end.
I'm wondering if its the cables, but I have tried two of them. I had to have them made by a third party cable vendor since the CX3 uses SFP on its end and the older DAE2's use HSSDC1 on the PRI port instead of HSSDC2.
If I plug in a SFP-HSSDC2 cable into the SP it is fine, but obviously that doesn't help me with the DAE2.
Please help. I need this ATA array to implement a backup to disk scheme.
