Attachment uploads are currently disabled. This is a temporary situation and will resume as normal in the coming days.
Solved!
Go to SolutionAdding a vlan to a 6220 switch: Configuration Query
Hi All
We have Dell PowerEdge 6220 switches.
Currently, vlans have been added using the following method:
vlan database
vlan
exit
interface vlan
name
exit
interface ethernet 1/g1
switchport mode trunk
switchport trunk allowed vlan add
exit
I need to add further vlans onto the switches.
What I want to know is whether the second step of:
interface vlan
name
exit
is necessary to allow me to add the new vlans to the interface(s)?
I'm not interested in naming the vlans but don't know if it is necessary to declare "interface vlan " to enable me to add the vlan to the interface(s). I'd rather not do this as I need to add approximately a 100 vlans and there is no real benefit from naming them for our setup.
Thanks in advance!
John
Hi Todd
I'm pretty sure that this answers my question. Just to check that I have understood properly, the following configuration will allow me to add the new vlan 1139 to our switches:
enable
configure
vlan database
vlan 1139
exit
configure
interface ethernet 1/g1
switchport trunk allowed vlan add 1139
exit
Repeat for all interfaces!!!!
exit
copy running-config startup-config
Many Thanks
John
Hi Thilo
I have seen range configuration before but haven't used it - so thanks for pointing that out otherwise I would have done all the interfaces separately! I have put my new configuration script below.
I have 2 short follow-on queries to ask to you don't mind?
1) When doing a range configuration, will it leave the current configuration intact on all interfaces unless an item is explicitly removed?
2) I want to configure the ranges 1/g1 to 1/g16 and 2/g1 to 2/g16 - can I do this in one operation? (I have scripted in 2 separate operations below).
Thanks
John
enable
configure
vlan database
vlan 1139
exit
configure
interface ethernet 1/g1-1/g16
switchport trunk allowed vlan add 1139
exit
interface ethernet 2/g1-2/g16
switchport trunk allowed vlan add 1139
exit
exit
copy running-config startup-config
ThiloWunderlich
37 Posts
2126
0
Posted September 1st, 2011 08:00
1) It should leave the config intact
2) you have to do this in 2 operations
Thilo
ThiloWunderlich
37 Posts
2126
1
Posted September 1st, 2011 02:00
Just to keep you from doing too much work and in case you do not know it:
Repeat for all interfaces
can be done with a range configuration:
interface range ethernet 1/g1-1/g5