Solved!
Go to SolutionOptiplex 9020 Boot Failure
I've got a 5 year old Optiplex 9020 that is failing to boot. By that, I mean when power is applied to the CPU, the unit appears to be powering up for about 2 secs, beeps once and restarts, repeating over and over. It never gets to the point where the diagnostic LEDs power on or you can run pre-boot diagnostics.
I tried swapping out the power supply from a working 9020 but that had no effect. I tried disconnecting the hard drive and DVD drive but that had no effect either.
Seems likely this is a motherboard issue but I've never had one fail so I'm not familiar with the symptoms for that.
Any suggestions?
16563
1
Posted November 22nd, 2019 07:00
I'll have to admit I was skeptical that changing the CMOS battery would make any difference but it did.
It stopped the reboot loop which allowed the power button LED blink diagnostic to run. I am getting a 2 then 3 blink pattern which the manual says is "system board, memory or CPU failure". That's about the worst message because it's the least specific.
As luck would have it, the warranty just expired in August so I'm afraid after stripping out some useful parts this PC is headed for the recycle bin.
Thanks for your suggestion.
16552
1
Posted November 22nd, 2019 10:00
Glad I was able to help!
I am not a Dell employee...I am forum volunteer
Serious work on an E5430 and constantly building and working on an i5-6500 Desktop
16504
1
Posted November 25th, 2019 06:00
We have multiple 9020s at our school that have the same issues. What I have found is if you go in remove and replace the RAM and do the same to the CMOS it should clear the error. I am not sure why but it seems to only be the 9020s that have this error. I am not sure why only this model does this.
16482
0
Posted November 25th, 2019 19:00
16293
0
Posted January 23rd, 2020 09:00
Please explain where the coin battery is located. And, did that replacement solve the boot loop problem. My computer is experiencing exactly the same symptoms.
16284
0
Posted January 23rd, 2020 10:00
Does replacing the battery solve the boot loop problem described earlier? Our Dell won’t boot, tries over and over with beeps in-between — I am cautious as that battery is for date and time, so why would date and time correct a reboot looping problem? I am a layperson who knows very little about hardware
16288
0
Posted January 23rd, 2020 10:00
Where the coin cell is depends on which size 9020 you have.
Duracell DL2032 works in all models.
https://www.amazon.com/Duracell-Lithium-Battery-Lasting-Count/dp/B07GN8ZYZR
15255
1
Posted May 18th, 2020 16:00
The "coin" battery not only "holds" the date and time in the PC, but also certain BIOS/CMOS settings. These settings can be reset by removing the battery, waiting 15-60 seconds, then re-installing the battery. After this you have to go into BIOS to reinstate your desired settings.
The weak battery described may not be holding all of the settings.
2352
1
Posted July 2nd, 2020 04:00
In my case, indications were that the system board had a problem. This is an older PC that is out of warranty. We decided to recycle.
JOcean
11 Legend
•
12621 Posts
•
69453 Points
16570
2
Posted November 22nd, 2019 06:00
Try replacing the CMOS (coin cell) battery. I am not sure which form factor you have but the following is for the MT.
https://www.dell.com/support/manuals/ca/en/cabsdt1/optiplex-9020-desktop/opt9020usffom-v2/removing-the-coin-cell-battery?guid=guid-c7a959d8-e82c-4119-a88a-06f8250f83c2&lang=en-us
I am not a Dell employee...I am forum volunteer
Serious work on an E5430 and constantly building and working on an i5-6500 Desktop