UNSOLVED
B
bkaczmarek
2 Posts
0
730
October 27th, 2021 20:00
R7525
On the R7525 with a CX94X, CRD,NTWK,PCIE,DP,25G,57414,FH, Slot 5 and the LOM, KHCTP, CRD,NTWK,BCME,OCP3,25G,2P,V2, after BIOS/UEFI firmware initialization, hit F2, the LOM, the leds are showing linked but the CX94X leds are not. The CX94X does become active after VMware loads and OS shows port up. I looked at all the setting between the CX94X and the KHCTP, not seeing a difference. Is this by design or am I missing something.
Thanks
Bob
bkaczmarek
2 Posts
555
0
Posted October 28th, 2021 19:00
Hello Marco,
Thanks for responding, I am not a network engineer, so educate me, the card is not showing a link, the Switch port is not showing a link, the card doesn't grab a IP address until the OS loads, do you link the network scan will find the card?
DELL-Marco B
Moderator
•
3980 Posts
535
0
Posted October 29th, 2021 10:00
Can you try to change BIOS boot omde in legacy and UEFI? Any differences?
Thanks
Marco
DELL- Marco B
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!
DELL-Marco B
Moderator
•
3980 Posts
580
0
Posted October 28th, 2021 00:00
Hello,
actually I don't know if is it normal or not that LEDs are showing after OS load.
Can you test if CX94X is active with a LAN network scan?
Thanks
Marco
DELL- Marco B
Social Media and Communities Professional
Dell Technologies | Enterprise Support Services
#IWork4Dell
Did I answer your query? Please click on ‘Mark as Accepted Answer’. ‘Thumbs up’ the posts you like!