Thank you wonrx for your feedback.

When we configured with usb key the 2 SP, we put them in the same network. for exemple : SPA: xx.xx.xx.40 and           SPB: xx.xx.xx.41

we must put the same IP address  on both the 2 SP ?

how can I change the IP of one SP, it is the part interface (Sync Replication Management Port)?

BR

You are confusing a Unity perhaps with a VNX?

Unity only has one management interface which floats between both SPs, depending on which is the primary.

There is ONLY one IP for Unity management.

You need to follow the setup guides carefully.

Andre @ Dell EMC

Thank you. it is right

Was your question answered correctly? If so, please remember to mark your question Answered when you get the correct answer and award points to the person providing the answer.

Remembering to mark the question Answered helps others with similar problems and awarding points helps motivate people to take the time answer you questions. Forgetting this may affect responsiveness.

glen

Is it possible to shed some light on the logic being used in selection of iscsi initiator path selection between SP A ports , there are two ports marked port 2 and port3 on Dell unity 300 for 10GB connection. Say we have one initiator with four paths, two for SP A and two for SP B with two VLANS , VLAN 3 and VLAN 4. So VLAN 3 is available on port 2 of SP A and SP B , VLAN 4 on port 3 of SP A and SP B. In all we have total 4 initiators and 16 paths.

Hello TXANAND,

Here are a couple of links to a couple of KB’s that maybe of assistance.

https://dell.to/3fzZ7Ne

https://dell.to/3dqtl2v