UNSOLVED
Adding cache memory
I did a quick search of the forums and hadn't seen this asked so I apologize if it was...
Can you add additional memory to a CX3-10? It currently has 2GB of cache memory.
We are getting our SPs swapped out due to some hardware issue and when I was checking the parts dispatch I noticed that each SP has 4 DIMM slots and the RAM that was in there was simple DDR2 ram.
It would be nice to have another 2GB or so of cache, but I'm guessing there is a gotcha here.
1. If I added RAM to the SP, would it automatically be recognized or is there some block internally to prevent you from doing so?
2. Would EMC/Dell have a fit if I were to do that? It's not like a total upgrade of the SAN... you still have the slower processors and other limitations...
3. Has anyone else ever done this successfully?
Thanks
Can you add additional memory to a CX3-10? It currently has 2GB of cache memory.
We are getting our SPs swapped out due to some hardware issue and when I was checking the parts dispatch I noticed that each SP has 4 DIMM slots and the RAM that was in there was simple DDR2 ram.
It would be nice to have another 2GB or so of cache, but I'm guessing there is a gotcha here.
1. If I added RAM to the SP, would it automatically be recognized or is there some block internally to prevent you from doing so?
2. Would EMC/Dell have a fit if I were to do that? It's not like a total upgrade of the SAN... you still have the slower processors and other limitations...
3. Has anyone else ever done this successfully?
Thanks
DGM3
238 Posts
218
0
Posted August 15th, 2008 11:00
The Storage Processors in each storage system support a fixed amount of memory - adding or subtracting memory is not supported. Memory per SP (multiply x 2 for the total amount in the storage system) is 1GB on CX3-10, 2GB on CX3-20, 4GB on CX3-40, and 8GB on CX3-80.
Regards,
DGM