UNSOLVED
M
mikemerton
7 Posts
0
1396
October 30th, 2007 21:00
Blu-Ray Drive error
Hello, I have a 720 H2C with the Phillips Blu-Ray drive. The monitor is the Dell 24 inch widescreen.
When I insert the Blu-Ray DVD that came with the system the disc starts and then an "HDCP error 0107" appears. I'm using the PowerDVD DX that came installed and have downloaded an update that was available on Cyberlink's site.
I'm also using Windows Vista Ultimate.
The message tells me to use an analogue cable instead of the DV cable. Does that make any sense...'cause I'll have to dig up the adaptor.
The video cards are 8800 GTX's in SLI mode with the latest Nvidia drivers.
Thanks!
108
0
Posted October 31st, 2007 11:00
Hi Mike,
From some of the hits on Google, I had gathered that might be the issue but since I was not familiar with the item, did not want to mislead you.
Best Regards!
God, grant me the senility to forget the people I never liked anyway,
the good fortune to run into the ones I do and the eyesight to tell the
difference.
CD/RW Link
108
0
Posted October 31st, 2007 11:00
I guess I've determined that the 2407FWP is not HDCP compliant through the DVI connector...too bad because it's a great monitor that set me back over a thousand bucks two years ago.I've ordered the Ultrasharp 27 inch which is HDCP...I'll sell the 2407 at a steep discount!Thanks
Predator
2 Intern
•
15286 Posts
108
0
Posted October 31st, 2007 03:00
Hi Mike,
Not really sure if this is a CD/DVD hardware issue but I ran a quick Google Search on the error message you listed and came across a number of suggestions. Have you tried a search from Google on this yet?
Best Regards
God, grant me the senility to forget the people I never liked anyway,
the good fortune to run into the ones I do
and the eyesight to tell the difference.
CD/RW Link