PS4000 - Getting ISCSI event warnings on hyper-v hosts - events 9, 39 and 129

Question

A week or so ago, a co-worker did some live migrations, during that time one of the hyper-v hosts bluescreened. We've been getting ISCSI warnings - 9, 39 and 129. I've researched it but don't have anything conclusive. One doc I found suggests turning off Jumbo frames.  Event ID 9 seems to be a non-issue. Another doc suggests this. 'Event ID 9 is logged when the target did not complete a SCSI command within the timeout period specified by SCSI layer. The dump data will contain the SCSI Opcode corresponding to the SCSI command.   Please try the following resolution to solve this issue:====================================== 1. On the Windows system, click Start, click Run, type regedit and press Enter.WARNING: As serious problems might occur if you modify the registry incorrectly, please refer to the following KB article to back up the registry before you modify it:   How to back up and restore the registry in Windows http://support.microsoft.com/kb/322756/en-us   2. In HKEY_LOCAL_MACHINE\System\CurrentControlSet\Services\Disk, edit or add the TimeOutValue entry to set it to 60 seconds in decimal format (0000003c in hexadecimal).-- To edit the value for the TimeOutValue entry if it already exists, double-click the entry, enter the new value, and click OK.   -- To add the TimeOutValue entry if it does not yet exist, right-click anywhere in the list of values, and then click New > DWORD value. Name the new value TimeOutValue, and then double-click it to edit the setting. Note: If you are not running iSCSI Initiator v1.05a, you can also check the following: Go to the registry value MaxRequestHoldTime at the following registry key:HKLM\SYSTEM\CurrentControlSet\Control\Class\{4D36E97B-E325-11CE-BFC1-08002BE10318}Increase the value to 90. If that does not work, try 120. Meanwhile, please also contact to your iSCSI device manufacturer to confirm whether this issue is caused by the iSCSI device.' Any advice?

Kuztnitsov · Answer

No events were logged on the PS4000 at the time of the bluescreen.

Kuztnitsov · Answer

and thanks for your help

EqualLogic

Was this post helpful?