Entering power save mode problem...Pls Help

Hi Himanshu_India,

To prevent this from happening follow the below steps:

1. Click Start button, click Control Panel, click System and Security, and then click Power Options.
2. On the Select a power plan page, click Change plan settings for the plan that you want to change.
3. On the Change settings for the plan page, click Change advanced power settings.
4. On the Advance settings tab, expand Sleep, expand Allow Hybrid Sleep, and choose OFF.
5. On the Advanced settings tab, expand Sleep, expand Allow wake timers, choose Disable for both when your computer is running on battery and when it's plugged in, and then click OK.
6. On the Advanced settings tab, expand USB settings, under USB settings expand USB selective suspend settings, choose Disable.
7. Click Apply and then OK to save the changes.

Check if the above steps work and reply.

thanks for reply i will try them and tell u the results tomorrow

Hi Himanshu_India,

Monitor may enter in power saving mode when it does not get the enough power for its operations. If monitor is the cause, you may try to re-seat the monitor cable
and ensure the connections are secure. You may also try to swap the ends of cable and check if the issue persists.

Another step you may try is to use a good known cable and see if the issue persists. If it does, as a last resort you may try to reset monitor to factory defaults using
the onscreen display menu of the monitor.

Kindly post the results.

I can see how this might PREVENT this from happening, but I obviously can't follow the instructions above until I've regained use of my screen, which is stuck in sleep mode.  How do I do that?

thanks its work

thanks its work