Unsolved
This post is more than 5 years old
7 Posts
0
48875
help dell r410 high fan speed
Hi guys ,
I recently notice that my server fans are loud so i checked the openmanage server administrator to find out if there was a hardware error.
There were no errors but i noticed one fan with a really high rpm ( 12000 rpm ) .
Other fans were below 8000.
What can be the cause of this ?
regards ,
Donovan
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
October 14th, 2015 10:00
Hello.
The iDRAC/BMC controls the fans' RPM which varies depending on the ambient temperature. Ensure that the iDRAC/BMC firmware and system BIOS is up to date
undermydesk
8 Posts
0
November 5th, 2015 07:00
Our R410 shows the same phenomena...
system board MOD 4A runs at 12840 to 13200 rpms
... everything is up2date here. resetting the IDRAC
(racadm reset hard) and/or rebooting the server
doesn't seem to 'fix' this.
I'm quite positive that our R410 didn't run at
this insane speed all the time - came across
this too when checking where the weird noise
comes from (doesn't sound defective - just louder
as it used to be).
Any clues?
Anonymous
5 Practitioner
5 Practitioner
•
274.2K Posts
0
November 5th, 2015 10:00
Hello.
Have you drained the system flea power? Disconnect AC cables then press and hold the server power button for about 15 sec and reboot. You may notice some drop in fans' RPM.
undermydesk
8 Posts
0
November 6th, 2015 05:00
Robert - thankyou for replying... ;)
We just went through the process you've suggested - but it didn't change anything.
FAN4 even raised its RPM and runs now on ~14000 rpms while all others are at 6000-8700 rpms.
What I noticed during testing/reboots was the message (emitted by something bios):
Fan 4 speed may change depending on system configuration and option card install.
... which - however doesn't seem to be the case here (at least it doesn't spin down a bit).
Digging around I came across (please read) this older thread:
http://en.community.dell.com/support-forums/servers/f/946/t/19287192
where a dell rep suggests that this behaviour is perfectly ok?!
Anyways - later in this thread some ppl claim that another update obviously fixed
something with regards to this fan4 speed...
... but it somehow didn't fix this for all of us?!
TIA for any more insights ;)
cheers,
frank\
molnar_tass
1 Message
0
March 21st, 2017 08:00
Hello,
Same situation here. But I had a solution for it that fixed it partially.
What I did is update all my firmware, Bios, Chipset, BMC (did that last)
After BMC firmware update to 1.92, A00 everything wen't quiet !! IT WAS SO AWESOME!
Everything works fine until i restart my system. (after system restart everything goes back to it's old loud RPM)
I repeated the BMC update again (the same version firmware reupdated and it works fine after update again.)
And after system restart it resets again...
Please help.
Regards,
Tass
undermydesk
8 Posts
0
March 22nd, 2017 05:00
... glad you got it sorted. ;)
Unfortunately... we are running the R410 with IDRAC Enterprise - and because of this we
cannot apply the BMC firmware upgrade you're referring to.
The IDRAC firmware is latest on our side (2.85 A00 / IDRAC reports this as 2.85 (Build 04))...
... but this firmware seems to lack the specific bits which silence the fan :(
cheers,
Frank