NPIV On core

Question

Hello, I asked this question about the edge switches last week, however, I also found out that in order to install our new DELL Compellent array, I need to enable NPIV on the CORE MDS 9509 switch. I have looked in powerlink and on cisco forums and it seems non disruptive. I just need a sanity check. I am not ready to define the ports yet, however, I just want to enable npiv. My apologies if the question seems redundant. We are doing year end processing now and I cannot afford to be incorrect! All I believe I have to do to is: config t enable npiv cntl z copy run start Thanks! Admingirl

dynamox · Accepted Answer

what did Dynamox say ?

admingirl · Answer

Found an older forum post already answered by Dynamox!!

cincystorage · Answer

show feature|include --ignore-case NpIvThat works to

dynamox · Answer

clap your hands and stomp your feet might work as well

cincystorage · Answer

I think if someone says your name in the mirror three times you appear behind them...

admingirl · Answer

LOL!! You rock Dynamox. sh feature |grep npiv config t feature npiv copy run start

dynamox · Answer

haha, it's the holidays man. I am on my way to Nashville, BBQ time

cincystorage · Answer

nope,&#xa0; tried it earlier today when I had a question and was to lazy ot post on the forum

cincystorage · Answer

mmm bbq...  I have some friends in Nashville...  Second best bbq i've had... first was Austin Texas...  Have a good holiday... don't work too much...

admingirl · Answer

Have a great holiday Dynamox! Thanks again for all of your help!

dynamox · Answer

yeah Nashville better not disappoint in bbq department, enjoy your holiday guys and gals !!!

Connectrix

Was this post helpful?