Unsolved
10 Posts
0
1185
SAS cable disconnect error messages R620
I have 2 x R620 servers with ESXi installed.
I replaced embedded RAID card with external RAID card and connected cables from HDD backplane to this card.
So, onboard SAS connectors are unplugged, SAS cables connected to external RAID card.
I don't see any error messages not in DRAC, not in BIOS not during system boot.
But all the time I am receiving error alert on my ESXi about server hardware health that looks the next:
ID Sensors Status Reading SEL entries Categories Last updated
0.26.1.224 Disk Drive Bay 1 Cable SAS A 0 Alert 2 0 Storage 04.05.2020, 11:33:42
0.26.1.225 Disk Drive Bay 1 Cable SAS B 0 Alert 2 0 Storage 04.05.2020, 11:33:42
How may I disable these error messages that has no sense?
Thanks
Dell-DylanJ
4 Operator
4 Operator
•
2.9K Posts
0
May 4th, 2020 14:00
Without knowing the ESXi version you're working with, the best recommendations I could make would be to reset the alarm. I'd also recommend checking the Lifecycle log to see if this message is being generated there. I expect that it likely is, and if that's the case, you'll need to either ignore the message or move to a supported hardware configuration.
KLCDredd
8 Posts
0
September 17th, 2022 09:00
Hi @SoftMaster did you ever figure out a solution to this?