lukehy

updated

5 years ago

L

lukehy

1 Rookie

•

61 Posts

0

3369

June 21st, 2021 05:00

dell scv2020 -controller not recognized after controller replacement

Hello.

i have an issue with a controller in dell scv2020.

i tried to replace the faulty controller but when replacing it with another controller

 the new controller is not recognized.

 

any ideas?

 

  • lukehy

    1 Rookie

    •

    61 Posts

    2589

    1

    Posted July 1st, 2021 09:00

    Hello Dylan.

    sorry for the late reply.

    when we replaced the controller we replaced the cache battery as well

    and it didnt initialize because the battery was still charging

    when we put the new controller in and swapped to the old battery, the old battery charged a little

    and the then the controller was initialized  and the error cleared.

    the issue is resolved.

     

    thank you and to @DiegoLopez  for the help!.

     

  • lukehy

    1 Rookie

    •

    61 Posts

    1818

    0

    Posted June 21st, 2021 07:00

    i have noticed that  although the beginning of the  dell part is the same (0W4TPR)

    but the revision and p/n on it is different :

    MY- 0W4TPR-63482 697-0s8e-A01

    P/n : 1000803-05

    and :

    Dell P/n : MY-04WTPR-63482-617-Oc32-A00

    P/n: 1000803-04

     

  • Dell-DylanJ

    6 Operator

    •

    2924 Posts

    1812

    0

    Posted June 21st, 2021 09:00

    Hello,

     

    Can you confirm that your replacement process followed the process in the link below? It's also worth noting that it may take 45 minutes to an hour for the software to update the new controller. 

     

    SCv2000 and SCv2020 Storage System Owner’s Manual | Dell US

  • lukehy

    1 Rookie

    •

    61 Posts

    1809

    0

    Posted June 21st, 2021 10:00

    Hello Dylan.

    i confirm that its the process i used.

    i have waited for about 20 minutes though not an hour

    and the controller still wasn't visible in the GUI.

     

  • Dell-DylanJ

    6 Operator

    •

    2924 Posts

    1808

    0

    Posted June 21st, 2021 10:00

    Let's give it a bit more time then and check back on it once it's had a bit longer to finish it's process. It may well be fine at this point, but we should know for certain before long.

  • lukehy

    1 Rookie

    •

    61 Posts

    1790

    0

    Posted June 23rd, 2021 04:00

    Hello Dylan.

    i have waited an hour but still the new controller is not being recognized by the Gui.

    any suggestions ?

     

     

  • lukehy

    1 Rookie

    •

    61 Posts

    1782

    0

    Posted June 23rd, 2021 06:00

    the error that i received before replacing the controller :

    an unrecoverable problem was found with caching hardware on controller during system startup.


    the new controller is still not recognized in the Gui:

    my question is this , is this the caching hardware  on the controller? :
    Cache Card.jpg

  • DiegoLopez

    6 Operator

    •

    2668 Posts

    1772

    0

    Posted June 23rd, 2021 08:00

    Hello @lukehy


    The error "an unrecoverable problem was found with caching hardware on controller during system startup" is normally related to a cache battery alert. Usually, when this error happens it is important to facilitate a serial connection to Dell Support level 2 for further troubleshooting because not always a controller replacement is required. Is your Compellent still in warranty?


    If you followed the procedure for replacement, maybe the new Controller is faulty or the error was not related to a controller replacement. Can you try to install the old controller and verify if the error persist and the old controller is detected at all?


    Regards.

  • lukehy

    1 Rookie

    •

    61 Posts

    1770

    0

    Posted June 23rd, 2021 09:00

    Hello Diego.

    i have put the old controller back and still got the the same issue .

    about the new controllers , we tried a few of them but none of them 
    started to initialize.

     

    this Scv2020 is not under warranty.

  • Dell-DylanJ

    6 Operator

    •

    2924 Posts

    1764

    0

    Posted June 23rd, 2021 10:00

    Hello,

     

    The cache shouldn't be separate from the controller. With both the original and the replacement reporting this same error, the issue may be with the connecting board. The only components I'm seeing in our database are either controllers, hard drives, or SSDs. If you're still able to get into storage center or storage manager, I don't mind looking at a log collection, but you may be best served talking to phone support. The Compellent systems usually have support options, even with an expired warranty. If that log review is something you'd be interested in having done, go ahead and acquire them, then reply with the file size, so we can find the best way to get them. If you'd like to go ahead and speak with phone support, I'd refer you to (800) 456-3355. I expect that there is a decent chance that I may need to refer you to them, even with a log review, but I did want to offer.