Hi, I have imported a lot of OIDs for our iDrac 9 on our R640, but actual temp readings through SNMP seem to be absent. I can get probes reporting UP or OK, but whether I try an import (this is on PRTG) or manually add the OID listed here: https://www.dell.com/support/manuals/en-uk/idrac9-lifecycle-controller-v3.3-series/snmp_idrac_cmc_9.3_ref_guide/chassis-status?guid=guid-669fbb93-9fdb-4171-bf89-ab7bfedea4bf&lang=en-us 

It reports that object is not found. 

I'm sure I'm doing something obvious wrong, but I've gone through the settings I could find to ensure that snmp is properly enabled.  

I'm not really a pro on the iDrac in general, only get into the interface when I rarely need to do something. So I could be overlooking something.

Appreciate any guidance.