Hi iramshiv,

To install the Intel Rapid Storage software you need to install the operating system with iSRT mode enabled in BIOS. You need to change ‘SATA operations’ as ‘Intel Smart Response Technology’ instead of AHCI in BIOS. You should be able to install Intel Rapid Storage after installing Windows 7 with iSRT enabled. After enabling iSRT in BIOS, you may follow the steps below to install Windows 7.

> Go to RAID BIOS and disable accelerate option for SSD (Only if HDDs are not detected while OSRI) (Use Ctrl+I)

> Initiate OSRI

> Install all the drivers including Intel Rapid Storage Software

> Then follow the steps below:

1. Run the Intel RST software through the All Programs menu or the task bar icon.
2. Click Enable acceleration under either the Status or Accelerate menu.

       3. Select the SSD to be used as a cache device.

       4. Select the size from the SSD to be allocated for the cache memory.

Note : Any remaining space on the SSD may be used for data storage using the simple data single-disk RAID 0 volume that is automatically created.

       5. Select the drive (or RAID volume) to be accelerated. It is highly recommended to accelerate the system volume or system disk for maximum performance.

      6. Select the acceleration mode. By default, Enhanced mode is selected.

Note: Enhanced mode: Acceleration is optimized for data protection.
Maximized mode: Acceleration is optimized for input/output performance.

      7. Click OK. The page refreshes and reports the new acceleration configuration in the Acceleration View. Your system is now successfully configured with the Intel Smart Response Technology.

Once this is done the SDD drive will not be visible in windows.

Hope this helps. Please feel free to reply for any further assistance.    

Thanks for the reply.... But how to get into RAID BIOS?

Hi iramshiv,

You may press + to enter the raid BIOS as mentioned in the previous post. Follow the next steps, once you are able to enter the raid BIOS.

Hy, ctrl + i is not working.....

Hi iramshiv,

You may try installing the operating system without making any changes to RAID BIOS. Enable iSRT in BIOS and reinstall the operating system. Once operating system is installed, you may install all the drivers along with ‘Intel Rapid Storage’ software. For correct order of drivers install, please refer to the link: http://dell.to/12kg7ed.

Hope this helps. please feel free to reply for any further assistance.

If I enable "ISRT" in bios it shows only "SSD" for installation ... So, I selected "load driver" option and loaded the "MOBILE EXPRESS CHIPSET SATA RAID CONTROLLER", even after it shows only SSD for installation.

Hi iramshiv,

As the operating system is already installed on the hard drive in AHCI mode, it seems the system is not able to recognize it in ISRT mode. I would suggest you to format the hard drive and then try to install Windows 7 with iSRT enabled. You may refer to the link: http://bit.ly/QJ0FEh.

*Note: Formatting hard drive includes data loss. i would recommend you to back up all the data before formatting.

Hope this helps. Please feel free to reply for any further assistance.

So, i should get into CMD in Advanced option using Win 7 DVD. Create those steps as in link, in my HDD. and install Win 7 with ISRT,  Am i right??? and any changes should be made in my SSD?

Hi iramshiv,

That is absolutely correct. You don’t have to make any changes to the SSD to install windows 7.

Keep me posted with the results. I will be glad to assist you.

I have successfully installed the isrt now. but there's no option for acceleration....