UNSOLVED
Clocks on N3048
Is there a way to manually adjust the clock on the switch, the only reason I ask is because I have 3 switches, all N3048's and we use an NTP server so one of the switches I was able to just add the NTP server on it and specify the timezone and it worked great, the other 2 need adjustments even though they are configured the exact same way, the time and date are showing to be off by alot.
DELL-Josh Cr
Community Manager
•
9698 Posts
•
43691 Points
3689
0
Posted December 16th, 2015 14:00
What is the output from show sntp server
DELL-Josh Cr
Community Manager
•
9698 Posts
•
43691 Points
3689
0
Posted December 16th, 2015 14:00
Are you able to configure an sntp server to pull time from?
DELL-Josh Cr
Community Manager
•
9698 Posts
•
43691 Points
3689
0
Posted December 16th, 2015 14:00
There is not a manual clock setting, You could try using the offset to correct it page 1843 downloads.dell.com/.../networking-n3000-series_Administrator%20Guide_en-us.pdf
Output is below, keep in mind that the time is CST 4:15pm on Dec. 16 2015
SWDC04#show clock
09:32:42 CST(UTC+0:00) Dec 13 2015
Time source is SNTP (not synchronized)
SWDC04#show sntp server
Server Host Address:
Server Type: unknown
Server Stratum: 0
Server Reference Id:
Server Mode: Reserved
Server Maximum Entries: 8
Server Current Entries: 1
SNTP Servers
------------
Host Address: 10.50.105.15
Address Type: IPv4
Priority: 1
Version: 4
Port: 123
Last Attempt Time: Dec 13 03:56:45 2015
Last Update Status: Other
Total Unicast Requests: 1
Failed Unicast Requests: 0
SWDC04#
DELL-Josh Cr
Community Manager
•
9698 Posts
•
43691 Points
3689
0
Posted December 16th, 2015 15:00
That one shows an ip address of an NTP server. 10.50.105.15
DELL-Josh Cr
Community Manager
•
9698 Posts
•
43691 Points
3689
0
Posted December 16th, 2015 15:00
sntp server 10.50.105.15
that should be all you need to do.
Marco1680
14 Posts
3689
0
Posted December 16th, 2015 14:00
Here's the funny thing this is the switch it worked correctly on, its almost as if the switch is not syncing with the NTP server, is there a way to sync them?
console>enable
Password:**********
console#show clock
16:42:26 CST(UTC-6:00) Dec 16 2015
Time source is SNTP
console#show sntp server
Server Host Address: 10.50.105.15
Server Type: IPv4
Server Stratum: 5
Server Reference Id: NTP Srv: 10.50.105.15
Server Mode: Server
Server Maximum Entries: 8
Server Current Entries: 1
SNTP Servers
------------
Host Address: 10.50.105.15
Address Type: IPv4
Priority: 1
Version: 4
Port: 123
Last Attempt Time: Jan 1 00:00:00 1970
Last Update Status: Other
Total Unicast Requests: 0
Failed Unicast Requests: 0
console#