DRAC/MC 1855 Blade Centre

I was trying to figure out this one also...

You can through the DRAC. The option is there. It is a manual process though and you can't have it autofill. I am using DRAC firmware 1.3 so I'm not sure if it is a new option or not but it is definately there in 1.3.

That sounds like a result. any chance you can post the steps you do to rename them, as I have looked in all screens and cant see anything obvious.

 

Cheers

Click on the configuration tab. Then click on the last tab at the top called "server". It will then give you the option of setting the server name for each server, although a manual process, it can be done.

Many thasnks, looks like I need to upgrade the firmware as I dont have this option on 1.2