Skip to main content

This post is more than 5 years old

Solved!

Go to Solution

Closed

nigelrs

1 Rookie

 • 

2 Posts

634709

April 7th, 2015 09:00

DELL C1760NW ERROR CODE 009-654

Searched high and low.  Seen this code come up on other printers but the solutions do not apply for the C1760NW.

Turned on and off. Turned off and on. Followed steps for other models only to get so far as the next stage isn't applicable and therefore it cannot be tested.

Is there anything that can be done on this for me to test and others who have this problem find this thread and also find a solution?

1 person also has this problem

SPM555

3 Posts

January 27th, 2018 11:00

Sadly this didnt work for me, I update to v1.078 (Mac OS) and this made no different on my non-wifi version of this printer 1765nf. 

Any other suggestions?

Ashkala

1 Message

March 11th, 2018 12:00

This doesn't work with my Mac either. Is it only a PC solution?

 

I've tried physically cleaning the sensors at the back and reinstalling any drivers yet this doesn't work. My printer is less than 3 years old so this is extremely frustrating.

MMMMeeee

1 Message

March 13th, 2018 14:00

First of all, its nothing like LED. I have questions, How deep should i clean (how deep should i put the cotton stick)? Should i clean from the sides in that hole? Is the sensor on the bottom or the top? Could you tell all that from the beginning?

Trash printer

1 Message

June 4th, 2018 09:00

Hi, i have tried your fix but, the printer keeps saying not ready, so i have been unable to download the latest firmware.

Any other solutions would be great.

FedupWthDell1760nw

1 Message

October 3rd, 2018 09:00

Hi,

Reinstalled the Firmware; cleaned the sensor; rebooted several times. Anyone can help? Thanks in advance.

JackNala

1 Message

March 29th, 2019 17:00

I get the error code 009-654 code 2010000. I wanted to try updating the firmware like you said, but it won't do anything because the error message is showing on the printer. When I try to download the new firmware it just says unable to update firmware while printer is not ready. What do you do for that???? It's like since it is in error mode it won't let me update any firmware for the printer. UGH!! Any help would be greatly appreciated.

bfq

1 Message

December 13th, 2023 16:42

Where specifically are the sensors and what is exactly do they look like? 

PawLurk

1 Rookie

 • 

5 Posts

November 23rd, 2024 14:08

I tried all the suggestions, short of dropping the printer several times, and nothing worked.

I noticed some Cyan Toner residue on one of the mechanisms when I opened the back.
Out of desperation, I removed the Cyan Toner Cartridge, then used an Air Blower (Compressed Air Can equivalent) to blow air into the Toner feed hole.   Put the Cyan Toner back in, and voila!

After an initial page or two that printed a little gunky, the Printer now works without Errors!

Hope this helps.

Was this post helpful?

View All

No Events found!

Top