How to Replace OCP for PowerEdge XR5610

This video will demonstrate the replacement procedure of an OCP card for the PowerEdge XR5610.

Prerequisites
Follow the safety guidelines listed in Safety instructions.
Follow the procedure listed in Before working inside your system.
Power off the system and all attached peripherals.
Disconnect the system from the electrical outlet and disconnect the peripherals.
If applicable, remove the system from the rack.
Remove the system cover.

Removing an OCP card:
Lift the blue retention latch lock to release the OCP card. Slide the OCP card out from the OCP riser.

Installing an OCP card:
Slide the OCP card into the OCP riser until it is firmly connected. Press down the blue retention latch lock to secure the OCP card in place.

Install the system cover.
Follow the procedure listed in After working inside your system:
Replace the system cover.
If applicable, install the system into the rack.
Reconnect the peripherals and connect the system to the electrical outlet, and then power on the system.