How to Replace the Back End NIC for PowerScale F200 and F600

This video will demonstrate the replacement procedure of a Back End NIC for the PowerScale F200 and F600.

Here's how to replace a Back End NIC on your PowerScale F200 or F600. To remove the top cover turn the screw, release the latch, then lift off the cover To remove the riser press the latches and lift it out. Release the clips securing the NIC and remove it from the slot.

Insert the replacement, close the, clips and replace the riser. To replace the top cover, first seat it on the pin of the latch, then close the latch, and tighten the screw. Thanks for watching.