TPM Option Is Missing in the System BIOS Setup Latitude, Precision, or XPS

Zusammenfassung: A TPM option may be missing in the system BIOS.

Dieser Artikel gilt für Dieser Artikel gilt nicht für Dieser Artikel ist nicht an ein bestimmtes Produkt gebunden. In diesem Artikel werden nicht alle Produktversionen aufgeführt.
Andere Ressourcen ansehen

Symptome

Note: This article is no longer being maintained. New and revised content about this topic is available at How to Troubleshoot and Resolve Common Issues with Trusted Platform Module (TPM) and BitLocker.

You may encounter a situation where the Trusted Platform Module (TPM) 2.0 option is missing from the BIOS setup screen, the Security option, or that there is no TPM present when running the Trusted Platform Module Microsoft management console (TPM.msc) in Windows.

This issue may become apparent as the result of a BitLocker recovery message.

NOTE: This only applies to platforms that support or can be switched to TPM 2.0. (Skylake and Newer systems.)

Computers with encrypted hard drives installed may also experience a no-boot situation if the TPM option is missing. Check the BIOS settings to ensure that TPM is not missing. Also, follow the steps below to resolve the missing TPM issue if a no-boot occurs on an encrypted hard drive.

Ursache

No cause information

Lösung

NOTE: Dell Technologies recommends that the entire installation base of applicable systems are updated, not just systems that are presenting issues with TPM.

If you are using UEFI boot mode, it is recommended to download and install the latest TPM 2.0 firmware version from Dell Support on applicable systems. The firmware is located under the Security category in the list of drivers. This new TPM 2.0 firmware should prevent this issue from occurring in the future.

If using Legacy boot mode, download and install the latest TPM 1.2 firmware version from the Dell Drivers & Downloads website on your applicable systems. The firmware is located under the Security category in the list of drivers.

NOTE: See our article on: How to Successfully Update the TPM Firmware on your Dell Computer.
NOTE: Search for drivers on the Dell Support Website by system model, not the service tag, as depending on the service tag entitlement, the TPM firmware files may not be displayed.

If TPM is not present, try the following troubleshooting steps:

  1. Update the system BIOS to the latest version available on the Dell Drivers & Downloads website.
  2. Power off the computer, then disconnect the AC power cable and leave the computer unplugged for about 30 seconds.
  3. Reconnect AC power to the computer and boot to the BIOS setup using the F12 one-time boot menu.
    NOTE: To ensure that TPM is turned on, you must press F2 to enter System Setup. Then go to the Security section and check that TPM is set to On under the TPM security settings.
  4. If TPM is restored, proceed with normal system operation.
  5. If TPM is still missing from the BIOS setup, contact Dell Technical Support for further assistance.

See these Dell Knowledge Base articles for related information:

Artikeleigenschaften
Artikelnummer: 000132757
Artikeltyp: Solution
Zuletzt geändert: 16 Juni 2025
Version:  21
Antworten auf Ihre Fragen erhalten Sie von anderen Dell NutzerInnen
Support Services
Prüfen Sie, ob Ihr Gerät durch Support Services abgedeckt ist.