Dell Unity：更换驱动器后，收到警报：系统无法启动数据的自动拷贝
Summary: 成功更换驱动器后，池可能仍显示为降级。警报显示没有足够的池备用空间或备用驱动器来从故障驱动器复制数据。系统无法启动数据的自动拷贝。
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
池中的驱动器出现故障，然后已成功更换。
驱动器已清除寿命终止 （EOL） 标记。
阵列中的驱动器出现故障，并且池报告降级，表明必须更换驱动器。
更换驱动器后，池继续显示降级，并显示以下错误之一：
"The system could not start an automatic copy of data from one or more drives in the pool to replace a drive that is wearing out, because spare drives are not available. Add drives to the pool." Or "The system could not start an automatic copy of data from one or more drives in pool <pool name>, because spare drives are not available."
Cause
更换驱动器后，Dell Unity Unisphere UI 未收到干净的状态更新。
管理服务器未将新状态发送到 UI。
Resolution
按照文章000019458重新启动或故障切换管理服务器：Dell Unity：如何重新启动或故障切换管理服务（用户可纠正）
如果池仍处于降级状态，请致电 戴尔支持中心 并引用本文编号。
Additional Information
有关其他情况，请参阅戴尔文章 000183486：
如果警报仍然存在，请联系 戴尔支持中心。
Dell Technologies 建议保持阵列 OE 代码和驱动器固件更新，以获得最新的可用增强功能和修复。
Affected Products
Dell Unity 300, Dell EMC Unity FamilyProducts
Dell EMC Unity 300F, Dell EMC Unity 350F, Dell EMC Unity XT 380, Dell EMC Unity XT 380F, Dell EMC Unity 400, Dell EMC Unity XT 480, Dell EMC Unity XT 480F, Dell EMC Unity 500, Dell EMC Unity 500F, Dell EMC Unity 550F, Dell EMC Unity 600
, Dell EMC Unity 600F, Dell EMC Unity 650F, Dell EMC Unity XT 680, Dell EMC Unity XT 680F, Dell EMC Unity XT 880F, Dell EMC Unity Family |Dell EMC Unity All Flash, Dell EMC Unity Family, Dell EMC Unity Hybrid
...
Article Properties
Article Number: 000081898
Article Type: Solution
Last Modified: 12 Nov 2024
Version: 7
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.