Article Number: 000204226
Figure 1: Example Topology
Instructions for setting up a port channel between two switches
configure terminal
command to enter global configuration mode, then press enter.OS10# configure terminal OS10(config)#
interface port channel 1
:OS10(config)# interface port-channel 1 OS10(conf-if-po-1)#
exit
:OS10(conf-if-po-1)# exit OS10(config)#
interface range Ethernet 1/1/33-1/1/34
:OS10(config)# interface range ethernet 1/1/33-1/1/34 OS10(conf-range-eth1/1/33-1/1/1/34)#
channel-group 1 mode active
:OS10(conf-range-eth1/1/33-1/1/1/34)# channel-group 1 mode active OS10(conf-range-eth1/1/33-1/1/1/34)#
end
:OS10(conf-range-eth1/1/33-1/1/1/34)# end OS10#
show interface port channel summary
:OS10# show interface port-channel summary LAG Mode Status Uptime Ports 1 L2 up 00:00:30 Eth 1/1/33 (Up) Eth 1/1/34 (Up) OS10#
show interface port channel 1
command:OS10# show interface port-channel 1 Port-channel 1 is up, line protocol is up Address is 0c:d3:b9:6e:00:51, Current address is 0c:d3:b9:6e:00:51 Interface index is 125 Internet address is not set Mode of IPv4 Address Assignment: not set Interface IPv6 oper status: Disabled MTU 1532 bytes, IP MTU 1500 bytes LineSpeed 50G Minimum number of links to bring Port-channel up is 1 Maximum active members that are allowed in the portchannel is 32 Members in this channel: Eth 1/1/33-1/1/34 …
show running-configuration interface Ethernet 1/1/33
:OS10# show running-configuration interface ethernet 1/1/33 ! interface ethernet1/1/33 no shutdown channel-group 1 mode active no switchport flowcontrol receive off OS10#
show running-configuration interface port channel 1
:OS10# show running-configuration interface port-channel 1 ! interface port-channel1 no shutdown switchport access vlan 1 OS10# Switch #1 show interface port-channel summary Switch #2 show interface port-channel summary
write memory
.OS10# write memory OS10#
For further assistance, see theDell Technologies SmartFabric OS10 User Guide Release Documentation or reach out to Dell Technologies Technical Support.
PowerSwitch S5048F-ON, PowerSwitch S5148F-ON, PowerSwitch S5212F-ON, PowerSwitch S5224F-ON, PowerSwitch S5232F-ON, PowerSwitch S5248F-ON, PowerSwitch S5296F-ON, PowerSwitch S5448F-ON, SmartFabric OS10 Software
30 Nov 2023
3
How To