Dell Unity: Unity OE 5.5.3으로 업그레이드한 후 상태 점검 오류 발생
Summary: 이 문서에서는 Dell Unity OE 업그레이드 후 "Fatal error detected" 메시지가 표시되는 한 가지 원인에 대해 설명합니다.
This article applies to
This article does not apply to
This article is not tied to any specific product.
Not all product versions are identified in this article.
Symptoms
Unity OE를 버전 5.5.3으로 업그레이드한 후 상태 점검에서 다음 오류를 보고했습니다.
PUHC failure:
Data Movers: Checking Status............................................Fatal error detectedCause
PUHC(Pre-Upgrade Health Check) 중에 보고된 치명적 오류는 svc_connectivityservices -s 명령이 실패를 보고합니다.
Resolution
의 결과에서 문제가 확인되면 svc_connectivityservices -s 또는 svc_supportassist -s 명령을 실행하여 문제를 해결한 다음 상태 점검을 다시 시도합니다.
다음 KB 문서를 참조하십시오. Dell Unity: 연결 서비스(이전의 SupportAssist)가 복구 절차를 위한 상태 점검 중에 실패했습니다 .
Affected Products
Dell EMC Unity 300F, Dell EMC Unity 350F, Dell EMC Unity 400, Dell EMC Unity 400F, Dell EMC Unity 450F, Dell EMC Unity 500, Dell EMC Unity 500F, Dell EMC Unity 550F, Dell EMC Unity 600, Dell EMC Unity 600FProducts
Dell EMC Unity, Dell Unity 450F DC, Dell Unity 300, Dell Unity 300 DC, Dell Unity 350F DC, Dell EMC Unity XT 380, Dell EMC Unity XT 380F, Dell Unity 400 DC, Dell EMC Unity XT 480, Dell EMC Unity XT 480F, Dell EMC Unity 650F, Dell EMC Unity XT 680
, Dell EMC Unity XT 680F, Dell EMC Unity XT 880, Dell EMC Unity XT 880F, Dell EMC Unity Family |Dell EMC Unity All Flash, Dell EMC Unity Hybrid
...
Article Properties
Article Number: 000446018
Article Type: Solution
Last Modified: 30 Jun 2026
Version: 1
Find answers to your questions from other Dell users
Support Services
Check if your device is covered by Support Services.