PowerEdge: 17th Generation servers fail to save multiple changes in UEFI Boot Settings

Summary: Settings are not saved in UEFI Boot Settings if more than one setting is changed.

Ez a cikk a következő(k)re vonatkozik: Ez a cikk nem vonatkozik a következő(k)re: Ez a cikk nem kapcsolódik egyetlen konkrét termékhez sem. Ez a cikk nem azonosítja az összes termékverziót.
További források megtekintése

Symptoms

Users that make more than one change in UEFI Boot settings experience an issue that causes the changes to revert and not save.

To encounter this problem, a user must navigate to F2 System Setup, Boot Settings, UEFI Boot Settings.

Figure 1: UEFI Boot Settings.

 

UEFI Boot Settings

 

From this screen, a user must first alter more than one setting. Next, the user must save changes and exit the BIOS. Upon returning to UEFI Boot Settings, any changes made are reverted.

This is the only section of F2 System Setup that is affected. All Intel and AMD servers are affected.

Cause

Pattern failure in the user interface.

Resolution

This issue is resolved in the December 2025 BIOS release.

 

 

NOTE: This issue only exists if more than one setting is changed in F2 system setup.
  • Users can change one setting and save it. The user may then come back into System Setup and make the other wanted change. After both changes have been saved separately, users should reenter F2 System Setup to confirm the wanted settings are saved.
    • A reboot is not required between each change. 
  • System setup through iDRAC web UI is not affected with this issue.

Érintett termékek

PowerEdge R470, PowerEdge R570, PowerEdge R670, PowerEdge R6715, PowerEdge R6725, PowerEdge R770, PowerEdge R770AP, PowerEdge R7715, PowerEdge R7725, PowerEdge R7725xd
Termék tulajdonságai
Article Number: 000366899
Article Type: Solution
Utoljára módosítva: 16 szept. 2025
Version:  1
Választ kaphat kérdéseire más Dell-felhasználóktól
Támogatási szolgáltatások
Ellenőrizze, hogy a készüléke rendelkezik-e támogatási szolgáltatással.